L2J Server

If you want to receive support we need this info to help you properly.
» Find Revision
L2J Revision Number:3973
L2JDP Revision Number:7124

and the upadted (on today) client from NCZ0ft

hy
i installed a upgrade from my server to the new epilog server , following your topics
it work's great
i chose as gameserver ID:16 Fehyshar

when i choose to enable the community board and launch the server i give's me this

Communityserthread: Tryed to connect 127.0.0.1 on port 9013
Communityserthread: Connecting to 127.0.0.1 on port 9013 failed

so i looked for a topic about community server's and i found one on the wiki
when i will follow the steps i'm comming on this points:

3.1) Edit the gameservers table. 'serverId' = 'CommunityServerSqlDpId', 'hex_id' = 'CommunityServerHexId'.
4.) Now, edit the community\data\top\servertopdir.xml file. Add your own GameServer(s) '<server sqlDPId="200" dir="Bartz" />' line, or change the file as your needs.

but mine doesn't exist, it's empty
is the same as the gameserver ?
Some idea?

thx for help

You need to download the Community server too:
http://www.l2jserver.com/svn/trunk/L2_CommunityServer/

If you do not want a new server for this there is a basic community in the gameserver, to enable this turn off the community server in the CommunityServer.properties file and enable in the General.properties file.

only this file ?

startCommunityServer.bat

i'd tryed the other it works, but i want to make it full

nop, the whole project, compile it, place in your server folder, set up it and initialize

i'll do that

thx a lot
great job, great people